S-10 Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
42 Posts
Discussion Starter #1
I used the pickle fork for seperating my ball joints and kinda tore the boots, can i pick up new ones and install them on the exisiting ball joint or am I going to need to repleace the entire ball joint?
 

·
Registered
Joined
·
295 Posts
you need to replace the boots, i dont know if they sell them separate. when i dd the front i did the bushings/tie rods/ball joints all at one time.


its not the short term that makes the disaster, after the dirt gets in there, it grinds the ball joints. once disrt gets in them, it may take 6-8 months for you to notice a stearing fault.
 
1 - 3 of 3 Posts
Top