[Altophobic]

i have been working on my truck all week and heres a few pics of my progress. ill go take some more right now to show what i did today..


scott
tell me what you think

 

[Altophobic]

drivers side notch

 

[Altophobic]

my gauges in the center console

 

[Altophobic]

do you think this is enough trimming? its about 2" tall and about 6" wide. its not finished i still need to grind it and get rid of some sharp corners and stuff.

 

[Altophobic]

bottomed out

 

[DropindaS-Mini]

i like that axle notch! look trick, what kinda link set up is that ??

 

[Altophobic]

its a airride airbar

its the bolt on air ride "airbar" i bought it from larry at http://www.innovativeairsuspension.com/

it looks like its gonna work it pretty good.
the notch is custom i made it from 4.5" .025 wall structural tubing and used a 4.5" hole saw to cut the hole in the frame.... i still need to box it in......



scott

 

[FLOWMINI98]

looks good bro......im in the middle of bagging my assend also.im at abuot the same point as you.....but im going mono leaf ....and the bags are being mounted between the leaf and the frame.
its sitting at the height it would aired out right now....and im bured into the pavement...my gas tank is on the ground.im still not laid out all the way though.i need lower control arms up front to take up the 3/4" gap between my front frame and the ground

 

[Altophobic]

does this look like enough trimming??

does this look about right for how much i should trim out of the front spring pocket???

scott

 

[Altophobic]

trying to post more than one pic......
scott

guess it didnt work

 

[Altophobic]

spring pocket

 

[hipoblaze]

you might need to trim a bit more, mine was like that after my first cut, then i set it on the ground thinkin i was done and sure enough whenn aired out my bag touched the spring pocket, i would say an easier way to do it rather then puttin it all back together would be to jack up the ower control arm, then check clearances around the bag you need 1/2" of space b/t the bag and anything it might rub on. this next time i take my frotn end apart i am gona trim even more on mine.

hope that helped some.


joshey

 

[Altophobic]

pic dident work

 

[Altophobic]

i need lower control arms up front to take up the 3/4" gap between my front frame and the ground

did you allready trim the upper bag mount? and it still wont lay??

scott

 

[Altophobic]

some new pics

heres some pics of the progress. i cut the mounts off my tank and made some straps to hold it to the cross member so it would tuck up alot higher in the frame.

scott

 

[Altophobic]

another

more pix, i still need to clean and paint it!!

 

[Altophobic]

heres a pic of where im gonna box the frame in. i need to weld it in tomarrow...

 

[Altophobic]

carbon canister

pics of the carbon canister and some other stuff that i did today.

scott

 

[Altophobic]

moved carbon canister

 

[Altophobic]

the almost finished c notch, i still need to put paint on it or maybe undercoating even though i hate that stuff.

scott