S-10 Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
I have a 2002 Chevy s10 extended cab I currently built these frame rails for a back half I am doing out of 4x2x1/8 but fish plating where I welded the pieces together the rail from back of step notch is 33inches from top of back rail the front I’m trying to figure out if I would cut pockets in existing frame to slide these in but I want this as one whole unit my step notch I made is 8inches high from inside and 9 3/4 on inside bottom will this clear...any input would be appreciated and criticism
340545
340546
 
1 - 1 of 1 Posts
Top