S-10 Forum banner
1 - 4 of 4 Posts

· Registered
Joined
·
547 Posts
Discussion Starter · #1 ·
Just wondering the dimensions of a tailgate filler for a first gen. I am thinking it is just a straight panel but not sure if there is a body line to match? I am going to try and weld in my own so any help appriciated....all I know is to use 18 guage steel. Where exactly does it weld up? I have an idea where to weld it but want to make sure. Thanks:zipit:
 

· Registered
Joined
·
547 Posts
Discussion Starter · #6 ·
THANKS FOR THE IDEA! How exactly does that work? Where is the best place to cut and weld if your putting on the blazer skin? Is it still the same size as my tailgate or should I cut below the body line?
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top