S-10 Forum banner
1 - 1 of 1 Posts

·
Pressurized 2.2 Member
Joined
·
3,241 Posts
Discussion Starter · #1 ·
I would like to drop a v8 motor in the truck in fact its just waiting. Its got a t-56 on her right now Im assuming I can use my stock clutch master cylinder and line just attach to the line on the tranny and bleed. Anyway My question is that how much hammering is needed to make it fit and would those rear axel relocator plates be all I need.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top