S-10 Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
166 Posts
Discussion Starter #1
Does anyone know how low you can go with dropped coil springs and still get the camber back right. Anyone who does alignments will know that you can only go so far out the the top of the upper control arm. I already have spindles but want to go down a little more.
 

·
Just a member
Joined
·
6,626 Posts
When my truck was dropped 5/6 they could align it just fine. It was 2 inch spindles and 3 inch coils. Not back to exact factory specs, but pretty good.
 

·
Hates 'know-it-alls'
Joined
·
26,065 Posts
I haven't ran across anybody doing a drop where they couldn't get it aligned good enough for daily driver's. If you can still drive it(by that i mean it's not so low that the front end is sitting on the ground) then you should be able to get it aligned close enough back to factory that you won't be able to tell a difference.
 

·
Registered
Joined
·
193 Posts
I've got 3" DJM drop coils with stock spindles...the alignment shop didn't have any problem with aligning my truck.

Call around to your local alignment shops, some of them don't like (or know how) to deal with modified vehicles.
 
1 - 5 of 5 Posts
Top