S-10 Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
50 Posts
Discussion Starter #1
Ok Just finished the v-8 swap and before i drive it i need to adjust the TV cable on the tranny. Its a 88' 700r4. Any suggestions or tricks to getting it right? Cause i heard if it is not right you can burn down the tranny.
 

·
Registered
Joined
·
745 Posts
yeap

Press the locking botton on the tv cable(located where it pushes through the linkage mount)and push the piece with teeth all the back towards the firewall,and then let go of the botton.Now you give it full throttle,at the carb (without engine running ) 1 time and your finished.
 

·
Registered
Joined
·
50 Posts
Discussion Starter #3
Ok i get it but do i need to hold the button in while i push the throttle. It doesn't seem like it will move if you dont. I cant try it untill tonight when i get it back from the exhaust shop.
 
1 - 3 of 3 Posts
Top