When I had carbed 355 in my engine I removed the Fuel sending unit, removed the fuel pump and drilled a hole in the top of the sending unit to install a 8an 90 degree bulkhead fitting. I then ran a 1/2 aluminum pipe to the bottom of the sender to draw fuel. I then ran 8an hose and 1/2 aluminum pipe to the engine.
if your running a stock to mild motor you can pull through the stock fuel pump without removing it itll work fine. but you do need to pull the fuel pump fuse.I believe someone else on this forum said the sender wire is purple but im not sure about that just make sure your sender is hooked up you should be golden
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
S-10 Forum
8.8M posts
183.1K members
Since 2001
S10forum is the community to discuss the S-Series, Chevrolet Colorado and GMC Canyon. Join to discuss rebuilds, modifications, tech articles and more!