S-10 Forum banner
1 - 3 of 3 Posts

·
S10 *****'s Youth Pastor
Joined
·
679 Posts
Discussion Starter · #1 ·
I just put a carbed 350 in my 1991 S10. I plugged in my factory harnesses to the tranny. I haven't pulled the computer but may cut some of the unnecessary wiring out.

What I'm needing to know is will my torque converter lock up on my 700r4 tranny with the factory plugs plugged into it?? and the rest of my engines sensors gone, and possibly the computer.

If not, can I wire it to do so??

Thank You very much for your help.
 

·
S10 *****'s Youth Pastor
Joined
·
679 Posts
Discussion Starter · #3 ·
I don't plan on eliminating my whole computer, just what I don't need. I don't want to burn my tranny up either.

I figure if the computer will do the job of sending the lockup the correct signal at the correct time, I'll leave the computer in it. I just hate to get my on the road and have any more wiring to deal with for a while.

Keep the facts comin' guys.
 
1 - 3 of 3 Posts
Top