S-10 Forum banner

1 - 3 of 3 Posts

·
praise the lower'd
Joined
·
1,024 Posts
Discussion Starter #1
is there anyway i can make my 3prong momentary toggle switches work like a 6prong??

the reason i ask is, i have the ART 2gauges and 4 switches in the stainless holder thing, and i only have up/down in the rear with 2 valves.

so i have a non working 4th switch. that i would like to make work for lifting/droping the whole front end.

is this possible.

thanks
scott
 

·
Registered
Joined
·
13,733 Posts
Yea.... you'll need four diodes... and just put two diodes on the two prongs that aren't power, then you'll now have 4 'pins' to use, in a sense, making it a '6' prong switch. :D
 

·
Registered
Joined
·
2,521 Posts
Another way is to put the valves on one side on relays. When the relay isn't energized, it will not let the power flow back thru. If you need any help with it, email me.
 
1 - 3 of 3 Posts
Top