S-10 Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
122 Posts
Discussion Starter #1
Hey guys,
I want to lower my truck...unsure how much yet and am thinking a 3/4. I have a1990 s-10 4.3 tbi.

I am thinking: 2 inch spindles, 1 inch coil for front
2 inch angled blocks and 2 inch drop leafs for the back

With this drop, would it be an actual 3/4 or would it actually drop more or less once everything settles in?

Thanks,
Scott
 

·
Registered
Joined
·
408 Posts
With most companys the stuff is almost right on track, but when it comes to coils it just might be a little off. But it sounds like a good combo :thumbup: If you have the money i would say get some shocks at the same time and do it all in one. It will ride much better with drop shocks rather then keeping factory stuff.
 

·
Registered
Joined
·
122 Posts
Discussion Starter #3
Hi,
I was thinking 2" drop leafs and 2" angled blocks because a freind of mine gave me 2" angled blocks.

One person recommended 3 inch drop leafs and 1 inch blocks...what do you think of this?

I have not looked into leafs yet do they make 2 inch drop leafs? I know they make 3 inch.

Scott
 

·
Registered
Joined
·
408 Posts
yep you can get leafs any where from 1-6"(6 using shakles), i would say the combo that you have is good, its all the same, they should not ride to much different, very little if at all would you be able to tell.
 

·
amatuer porn star
Joined
·
614 Posts
when i first lowered my truck it was a 3/4 but it seemed alot lower...it was 2" blocks and 2" leaves in the rear with 1" coils and 2"spindles in front
 

·
Registered
Joined
·
122 Posts
Discussion Starter #7
Hi,
Like how much lower?

Could you measure ur wheel wells for me....from ground to bottom lip of your wheel well?

Thanks,
Scott
 
1 - 7 of 7 Posts
Top