Hmm.. i wonder, i have center line rims on my old camaro, with 295's on them. i have a 89 S15 with a 4 inch drop in the back, i wondeer if they'd rub the frame rails!?
Cool look, did you have any rub problems? Also on the different spacing from one side to the other, I have seen differences in backspace on some wheels, especially aftermarket ralleys, they sometimes are off when they true them up before welding, one company I called said he could not get closer than 1/4 on my backspace measurement! The set I have now varies 1/8 to 1/16 between wheels.
no problems at all. pass side is fine drivers side i do think they did weld wrong because its closer to a 5 inch bs instead of 4.6. i have a little spacer ill put in there and im sure will even it out
Why don't you just loosen the u bolts and move the rear around
to get it square to the frame? It will move some on the locating
pins. get it stright front to back & side to side.GM doesn't align
the rears, if you check it its prob off a few deg. mine was off 6.
so i recentered it. Put it on an alignment rack to find out how
much its off.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
S-10 Forum
8.8M posts
183.1K members
Since 2001
S10forum is the community to discuss the S-Series, Chevrolet Colorado and GMC Canyon. Join to discuss rebuilds, modifications, tech articles and more!