S-10 Forum banner
1 - 1 of 1 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
Okay. I got the blazer about 6 months ago . I started the build About 1 month ago . This is where I have gotten too . Decided to start a thread . Any experience or knowledge is greatly appreciated .
I’ll start with the parts list

2004 Blazer
4.3 vortec 122,xxx
All Power interior
Little rusty exterior

Axle :
1988 wrangler Dana 30. 3.07 gear 250$

Leaf springs : 1996 Dodge Dakota rear leafs (4x4 not sure if it matters)

Spring hanger kit : Sky’s manufacturing
340$(after shipping & tax)

Rims & Tires :
15x8 stock Jeep rims
35x12.50x15 discovery stt 10%
Mount 100$

Shocks : Billistein 5100

Misc. :
Ubolts 40$
Spring plates : 30$
Leaf spring bushings : 40$

This was the general parts list . I think I hit most of what I got. Not including the tools that I have already .
The process was mostly straight forward . I ran into a few problems with bolt angles here and there . I didn’t seem to run into trouble with getting the differential out.
I still have to clean up the frame and get it painted .
I still have to get the break lines all redone .
I still have to get shock mounts.

I still have to figure out the steering . Which is where I think My biggest problem is going to lie .
Land vehicle Vehicle Car Automotive tire Tire

Disclaimer- some unsafe looking pictures here . I am alive posting this, am buying a new jack .

Now this is where I have it up too . It’s on its own weight .
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.