S-10 Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
35 Posts
Discussion Starter #1
I'm looking at putting a low profile crossover toolbox in my truck (2003 S10 ext). I have a pendaliner that goes over the top of the sides of the bed. The dude at the shop said since the bedliner goes over the top, I couldn't use the j-hooks to hold the box down....I'd have to drill through the top of the side to anchor it. Don't wanna do that.

So, couldn't I just cut a hole in the bedliner that would accommodate the J-hooks? Has anyone done this?
 

·
knifehandle.FT.trickery
Joined
·
285 Posts
my bed liner go over the top too, but it also has pre cut holes on the side,.. guy i bought it from had one of those tool box things.. so i would go for it
 
1 - 5 of 5 Posts
Top