S-10 Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter #1
What backspacing and size 20 should i go with in the front, and for the rear i can only get 22x10, but what backspacing should i get. I was told i will have to narrow the rear frame, but i was looking at a friends truck with 20x10 and he dosent hit the frame with them. anyone got any ideas?
 

·
amatuer porn star
Joined
·
614 Posts
i think 22" will stick out of the top of the bed in the rear......and with 20" up front youve got alot of work cut out for you.....
 

·
Registered
Joined
·
8 Posts
Discussion Starter #3
all my work in the front is done to stuff the 20's, im just worried about the rear, everything is cut out, i just dont have a actual rim to see if its going to hit the bed fenders, or hit the frame.
 

·
www.AcrophobiA.net
Joined
·
1,325 Posts
i have 20x10s in the rear............i had to pull my rear fenders out using braces in the inside of the fenderwell just to keep them from not rubbing......if i were you i would just narrow the frame.....otherwise you are going to be hitting your body a lot
 

·
Dis Member
Joined
·
87 Posts
vertex said:
What backspacing and size 20 should i go with in the front, and for the rear i can only get 22x10, but what backspacing should i get. I was told i will have to narrow the rear frame, but i was looking at a friends truck with 20x10 and he dosent hit the frame with them. anyone got any ideas?
Vertex, are you just bagged?

If your bagged you should be able to tuck a 22x10 but you might be looking at getting your rear end narrowed to get an offset so you don't rub the bedsides and the frame. On my rear i'm running a 20x8 with 5.5 bs to tuck on my body drop.

So ideally you're looking at 7.5 inch bs to tuck and not touch your bedsides, because the 22 is so tall it'll go up to the curved part of your bed. This will mean some rear end narrowing for sure. It's gonna cost money but it is possible to do what you're asking on a bagged truck.

Lemme know if I helped at all.
 

·
Dis Member
Joined
·
87 Posts
Now

It's in the shop right now, it'll be done in late April/ early May.
 
1 - 8 of 8 Posts
Top