[Brandonh36898]

Thats the best way i know to describe it

Has anyone did something like a false deck basically leave your stock floor of bed then build like a frame that would come up at the back of the notch cutout and run to front of bed.

So there would be a small section at the back of the bed open
But build a frame then cover it with sheetmetal. From where the bed cutout starts at back for notch then have it angle up or just go straight up and then flat to the front.

I was thinking it wouldn't be to hard and i could add like a hinged compartment to access the air tank etc.

I havent really seen anything like this most is bed floor cut out then framed but not much with only part of the bed floor cutout.

I hope i explained it good enough yall can visualize what i mean?

Id like to see some if anyone has done something like this.

 

[Rhotpursuit]

As they say...bags are for groceries. I think I get what you're saying, and it sounds like a good plan. That way, all of your components would stay clean.

 

[bk2life]

Id like to see some if anyone has done something like this.

just google raised bed floor. It is such a common thing in the lowered truck community, you shouldnt have too hard of a time find exactly what you want.

minirtuck raised bed floor - Google Search

 

[AVTekk]

Extremely common, done a million different ways, but yes usually just some frame built and filled with metal.

 

[nfamus10]

Dont over build it or your bed will take 6 grown men to lift it haha.