S-10 Forum banner
1 - 1 of 1 Posts

·
Registered
99 Blazer
Joined
·
283 Posts
Chevymec is correct on colors. If you want to confirm which wire is which due to color fade or something; pin A should have power from ECM IGN fuse 10, pin B should have ground, then of course your left over wire for the sensor signal will go to pin C. You can check A and B with a test light or voltmeter. There is a chance that fuse is blown if your wires touched each other with the key on.
Font Slope Parallel Pattern Rectangle
 
1 - 1 of 1 Posts
Top