S-10 Forum banner

Discussions Showcase Albums Media Media Comments Tags

1-20 of 58 Results
  1. ZR2 - BlaZeR2 - Highrider
    Hey guys hope yall are having a good start to your new year. i could use some help with some fuel issues that have persisted since ive owned this truck revolving around rough idleing and not wanting to start up after its been started and shut off. the sure fire way to get it started every time...
  2. ZR2 - BlaZeR2 - Highrider
    i have an 03 zr2 s10 that im looking into tuning and adding a 2-step and was wondering if anyone knows of any good ones out there
  3. Interior Styling
    I just posted this on another thread maybe you guys can help me too. I picked up this 1999 zr2 s10 and I’ve never another set of zr2 seats like them. Are they a rare factory option?
  4. ZR2 - BlaZeR2 - Highrider
    Does anyone have the OEM part number or an after market manufacturer part number for the clockspring? My clockspring failed (SRS light and wipers misbehave). I bought a replacement from Rock Auto for my application (2000 Chevrolet S10 4.3L), but it has a different connector than what is in my...
  5. 262ci Forum (4.3)
    Hi, I have a 1999 S10 with the 4.3L and NV3500. I also have a 2003 S10 ZR2 with a 4.3L Auto. The motor went in the ZR2. What is needed to swap both the engine and transmission into the ZR2 especially with the ECM. Thanks!
  6. S10 / S15
    The truck in question is my 2000 Chevy S10 ZR2 4.3 L V6 5 speed Manual. This is a bit of a story to explain, intermittent issues are weird. But I’m hoping to help other people in the future, please bear with me and give me your insight, this is a niche issue and I would really appreciate your...
  7. ZR2 - BlaZeR2 - Highrider
    Hey ive always been a fan of bench seats and when I was looking for my truck, I saw some, but ultimately I wanted the Zr2 for the lift, bigger motor, and 4x4. The question is can a bench seat be installed in a 2000 Zr2 ? obviously would have to remove the center console but whatever I don't...
  8. 4wd IFS
    I have a 2003 chevy s10 zr2 with the rough country lift kit on it. It has rough country upper control arms but I can't seem to find what bushings these use. Has anyone ever replaced theirs if so what bushings did you use? I prefer Moog but I'm not picky.
  9. S10 / Sonoma
    hello all, i have a 98 S10 ZR2 and i recently had the front end replaced (control arms, tie rods, etc) but i recently went to get an alignment and the left wheel won’t go further than -4.8 degrees of camber. the front right wheel moves perfectly for the alignment but the left will max out at...
  10. Steering & General Suspension
    Hi all, new to the forum here. I actually joined because this suspension has me totally lost. So I just bought an 03 s10 zr2 extended cab with 98k miles and I was thinking about redoing to whole front end suspension on it but I'm having trouble with what parts I should be ordering. The truck is...
  11. Electrical / Lighting
    Hey everyone! I started towing larger trailers with my 2002 s10 zr2. It doesn’t have the tow package but someone put a class 3 receiver hitch on it. So i wired In a 7 pin connector . But I was unable to find the brake pedal signal wire for the input to the controller. I have everything else...
  12. Transmission & Rearend
    Hi y’all I got a 2002 s10 zr2 a few months ago and I started noticing that the 4x4 was acting up. I don’t use 4wheel drive all the time but occasionally I need it. The issue is I can’t get the truck into 4hi only 4low with a lot of hesitation. It’s an electronic engagement no 4wd auto though...
  13. 4wd IFS
    Hi, I got a 2002 zr2 s10. I was wondering about a lift kit I know the zr2s are higher than a regular s10 from the factory but I was wondering how big of a lift kit would I need to make any difference in the height? I would like to put 33s on it and only cut a little of the fender flares, I got...
  14. ZR2 - BlaZeR2 - Highrider
    I've been noticing on my '96 ZR2 that there is noticeable "camber", or toe-out, sometimes when I look at it from the front while it's parked. Most of the time it's toed out, however, sometimes it's the opposite, it looks like it's toed in. The outer edge of my tires are starting to wear...
  15. 262ci Forum (4.3)
    SES light is on. has been on. P0300 P0137 P0140 P0141. The codes the scanner has brought up. Still working on finding the reason for P0300 but unsuccessful as of yet. Anyway, sometimes while driving at 30mph-40mph the SES light flashes. then stops at 41mph and starts again at 50mph and stops at...
  16. 4wd IFS
    Hello, I have a 2002 zr2 s10. I have been upgrading it slowly and when I bought a new set of headlights for it, the man also sold me a set of bigger keys and shackles. I believe it’s this one or one very close to it...
    zr2
  17. Liftin' It
    I recently bought a 1995 S10 ZR2. I am getting the ball joints replaced but my mechanic advised me that the whole suspension up front is on its way out. I wasn't planning on doing a lift or anything yet but I've heard that ZR2 front suspension is not great so this feels like a good time to get...
  18. ZR2 - BlaZeR2 - Highrider
    Hi everyone I recently bought a 95 S10 ZR2 ($4k if you're curious) and I am thinking about some things I'd like to switch to the facelifted version on it but I'm not sure how possible/easy they would be so any advice or help would be appreciated. 1. Has anyone done a steering wheel swap to the...
  19. S10 / S15
    I’ve had 4wd problems out of my 2003 s10 ever since I’ve had it. It only worked when it wants to and used to never go in 4 low now it does every now and then. I’ve been working on a manual conversion all morning. Got the actuator bracket remounted with the cable in it and a cable attached to it...
  20. S10 / S15
    I have a 2003 s10 Zr2 and as a lot of you know it has the push button 4wd system. I bought it with the transmission needing a rebuild, and before I even got the trans put in I replaced the switch on the transfer case. When I first got it running, 4wd only worked when it wanted to but I didn’t...
1-20 of 58 Results
Top