S-10 Forum banner

Discussions Showcase Albums Media Media Comments Tags

1-17 of 17 Results
  1. Suspension
    I've started making new Rear Sway Bar Brackets for the trucks - S10, S15, Sonoma, Hombre. These are designed using General Motors original specifications for the ZQ8 Xtreme handling suspension package and are a direct bolt on for many 96+ trucks. Older trucks do not have the factory holes in the...
  2. 262ci Forum (4.3)
    I'm wanting to replace the distributor in my 2001 4.3. How important is it that I line it up to TDC like everyone in the videos I've been watching has done? Wouldn't it be just fine if I put the new one in exactly how the old one came out? Any information is appreciated. Thanks!
  3. 262ci Forum (4.3)
    So i've had P1336 for awhile ( Crankshaft variation not learned) even though the vehicle runs fine. gets up to speed, no hesitation. It won't go through via scanner, and i'm starting to go down the line of different solutions. 1. Maybe replacing the Crank shaft position sensor? I've heard you...
  4. Xtreme / ZQ8
    Ok so I have a 2003 S10 Xtreme and my rear-end went out. I've tried to find one locally but every one I find is different. I'm beginning to think that the previous owner may have stuck a 4wd rear-end in it. Is this possible? I know when I went to buy new universals they told me I was buying one...
  5. Xtreme / ZQ8
    Hi, I’m new here, and I have a ‘01 Xtreme that I’d like to turn into a corner carver rather than a drag car. I was just wondering if anyone has a flush set-up on their Xtreme. I’ve seen a few online, but no info with them.
  6. LSx Discussion
    I recently picked up an 02 S10 that I'm planning on doing an LS swap in. I'm hoping to save as much as possible in the short term and I was wondering if anyone has done a swap and kept the stock NV3500 trans and if so what motor mounts work best for it? I am planning on putting a T-56 in at a...
  7. Blazer / Bravada / Jimmy / Envoy
    I'm currently trying to install a set of aftermarket blazer mirrors onto my s-10 Xtreme, as I prefer the look of them. The problem is the nuts that attached to the original s10 mirrors do not fit onto the blazer mirrors. I was wondering if you guys happened to know the size of the threading so I...
  8. Xtreme / ZQ8
    I have a 2002 4.3 S10 Xtreme and the previous owner curbed the wheels pretty bad. I want to get new wheels. It came with 16 inch wheels and I would prefer 15 inch wheels like a standard S10. I was told by a tire shop that 15 inch wheels wont clear the calipers and upper control arms. Is this...
  9. Xtreme / ZQ8
    Fist post. First truck. The noob special! I want to know if I can do donuts in my stock 4 cylinder automatic 2000 2.2L s10 xtreem. It's all stock but I want to know if It will do a decent doughnut with some smoke or will I just look like a loser driving in circles?
  10. Xtreme / ZQ8
    I've been trying to find a replacement for the past 2 months. Am I just an idiot or does the 2wd Pitman Arm have two holes instead of just one with a balljoint? Does anyone have a link to a vendor? Or maybe some advice? I have a 2002 4.3L 2wd Xtreme
  11. Xtreme / ZQ8
    Today I go to pick up my new 2003 Chevy S10 Xtreme with the 4.3. 110,000 on it, some crappy aftermarket "steelies" on the back and no exhaust. It needs paint, badges, a 4th stock Xtreme wheel, a front air dam, and just some touching up. Hoping too have some ideas bounced around. Will post pics...
  12. PatsBlueXtreme

    I looked for a good while to find this one. When I first saw it I was sold on it. Even more so when I drove it. The blue is so dark that it looks black at night. In the day it reflects the blue of the sky and looks even better. Of course it was only 4 1/2 hours from my house to go look at the...
  13. Exterior / Paint
    Alright guys, looking to replace the standard elephant ear folding mirrors on my 99 for something with more of a performance look but I dont have the first idea where to find some good quality aftermarket mirrors. Thanks for any help!
  14. 262ci Forum (4.3)
    Hey, 2000 xtreme 4.3 keeps giving #3 misfire code. I've now changed Plugs, wires, and cap with no luck. Any ideas what could be causing this. I have run seafoam thru to clean injectors, carb and crank. Check light still on and misfiring.
1-17 of 17 Results