S-10 Forum banner

Discussions Showcase Albums Media Media Comments Tags

1-11 of 11 Results
  1. 2.2L - 2nd gen 4-banging
    Hey y’all! I posted on here a few months ago about rebuilding a 1994 2.2. I was overthinking lots of stuff, and still am, but I decided to just “send it” and put it together. There’s a good chance it’ll blow up because I used scotch brite to clean nicks off some of the bearings before later...
  2. LSx Discussion
    Hello! After all this time of bugging you guys on here I'm very slowly starting to acquire some parts for an 4.8/5.3 swap on my s10, I have a couple questions though about the wiring aspect. Possible too keep the stock gauges? and how the heck does one mangle the wiring harness too get...
  3. S10 / Sonoma
    I'm not sure why I could be getting no spark. I had an aftermarket cd deck I installed in my truck and one day I had the truck running and I bumped the radio and the truck started to shut down so I wiggled the radio and the truck went back to running normal again. I later on switched out the...
  4. Electrical / Lighting
    Hey all, I cannot for the life of me find a OEM replacement under-hood wiring harness for my 2000 S10 4.3L 2WD with a 4l60e auto trans. The auto electrical shop I took my truck to quoted me 4k to replace the harness and $1600 to repair the old one to "like factory". I can't justify that as I...
  5. Electrical / Lighting
    Hello everyone. I’m new to the forums and new to s10s and ls engines, coming from a diesel world and wanted to try something new. I have a 1999 2wd s10 it’s a base model crank windows and the truck does not have hvac (my choice). Engine is a 2000 lm7 engine with minor upgrades.Anyway very close...
  6. 262ci Forum (4.3)
    I have a 01 Blazer 2dr, 2wd,5spd, 4.3l, and the original motor blew up so I put a 4.3 from an Astro Van in it. The van was running perfectly fine before someone rear-ended it, and i was able to snag the motor. The van was automatic but everything looked the same, i plugged everything in, and...
  7. Electrical / Lighting
    I’m about to install the factory dash in my 93 s10 blazer 2wd 2 door. When I got the project it was already out and totally disconnected. It’s getting an ls swap and for right now the radio won’t be hooked up or installed. Ignition will be on a panel so no ignition cylinder / stock column at...
  8. Wanted, to Buy
    Looking for a 4.3L auto trans 4x4 engine harness for my 01 ZR2. Grey/silver pcm. Hopefully somewhere in Colorado, or reasonably shipped. U pull and pay price is $30, non u pull and pay price is $80, looking in this price range. Needs to be complete, including all transmission and t-case connectors.
  9. S10 / Sonoma
    I’m in search of a wiring diagram for next to cpu or another engine harness I just got the truck did a tune up (plugs wires distributor cap and rotor) and plan draining and cleaning the tank this weekend since the truck sat for about 2 years. Ive been fixing wires that were ate up by rats I was...
  10. S10 / S15
    I'm starting a 1991 project truck it is super clean and almost zero rust. The truck has already converted over to a v8 set but has a ton of unused wiring in the engine. Is there someone that has a wiring delete diagram and a idea of what wiring has to stay... I have removed wiring harness from...
  11. Working area
    Hi folks & Tech Exchange editor. I just bought a 2003 Chevy S10 Ext Cab 4.3l v6 Fleetside with 89k on it. I bought it to haul a small travel trailer (1000 lbs dry weight). Looking around underneath the rear end to check hitch & wiring options and saw the following. Wondering what two items are -...
1-11 of 11 Results
Top