S-10 Forum banner

transfer case

  1. Transmission & Rearend
    Hello fellow enthusiasts! Total newbie to the forum here and hoping someone of you smart folks might be able to help me with a problem I'm having with my NP236 t-case. A little back ground, I'm installing a newly re-manned NP236 with newly re-manned encoder motor and TCCM. I got everything...
  2. Transmission & Rearend
    Hello everyone, O2 S10 ZR2 with NP 233C Transfer case I'm currently working on replacing my transfer case input shaft seal and noticed that the connector on the encoder motor had fluid leaking out of it. Does this normally happen when the input shaft seal goes bad and fills the case with...
  3. ZR2 - BlaZeR2 - Highrider
    Hi guys I'm currently working on my 02 S10 ZR2 that needs a transfer case input shaft seal replaced and I've got a few questions that I hope someone can answer. 1.) Do the bolts for the bearing retainer need some sort of thread sealant or thread locker when reassembling? Here's a photo of the...
  4. S10 / Sonoma
    I'm banging my head against the wall and hoping someone can help. I purchased a 96 4.3l 4wd pickup in decent condition, but the 4wd isn't working. I'll list the things I've tried as I've narrowed it down significantly. The transfer case shifts in and out fine. When engaged, the front drive...
  5. Transmission & Rearend
    I own a 2002 S10 ZR5 (160k miles), it's been stationary for 7 years. It was until these last few months I've had the means to fix her up and get her running. I gave her a tune-up (spark plugs and cables), new brake rotors and pads on every wheel, new rear end axles, bearings and fluid, new...
  6. Pay It Forward
    I own and operate a transmission shop in central Texas and have been a gear train specialist for 20 years. I owe this forum and community a great deal as I pretty much built my hot rod from information I found here posted by kind souls who did it first and shared... So, if you have any gear...
  7. ZR2 - BlaZeR2 - Highrider
    2000 S10 ZR2. Ok so i got my new rear driveshaft in and decided to take my truck for a drive. i bought the truck a few months ago and just got it running.. 4-hi the front driveshaft doesnt spin at all and 4-lo works like it should. i dont have any dashlights on and i hear the transfer case...
  8. ZR2 - BlaZeR2 - Highrider
    Ok so i bought a four wheel drive actuator which ill replace later. but there is a plug that screws in above the electric motor that has a nipple on the inside of the transfer case and three looks like vacuum line going to the front of the truck. when i took it out however i had an oil like...
Top