S-10 Forum banner

Discussions Showcase Albums Media Media Comments Tags

1-8 of 8 Results
  1. S10 / S15
    I hadn't found anything on this topic specifically for the 2.8 so I'm writing this up. Most of my lifters were ok but some of them I couldn't compress. They weren't primed and I read about emulsion buildup and rust so decided to take them all apart and clean them. To be honest I don't know what...
  2. S10 / S15
    Hey All, Longtime lurker, first time poster. I am in the middle of my 2.8 rebuild (Yeah I know, I should have but a 305 or at bare minimum a 3.4 in) Anyway, the new crankshaft came with a keyway for one long key whereas the old one had 2. Does anyone have an idea what the size of the single...
  3. S10 / Sonoma
    I am currently a rebuilding a 2000 S10 4.3 l VIN W. I wanted to do an EFI to carb swap, I knew this was going to be along the lines of an aftermarket computer and new harness, fuel pump,ect. I want to make it cool and all but i want to make sure to the airbags and safety systems work without...
  4. 262ci Forum (4.3)
    Hey folks. I'm looking to rebuild my 1995 4.3 TBI for 350 or so horsepower. I want to do a full carb instead of a TBI as I won't be going anywhere in high altitude. I want to supercharge it with a Wynjammer at some point. I'm aiming for a budget around 3k excluding the Wynjammer. Any...
  5. S10 / Sonoma
    First want to say thank you I’ve learned a lot on this forum. I’m a very amateur mechanic. I wish I would have posted/made account sooner when I started this build. Most of the hard work have been done. I’m closing in on the last half of the build. Cylinder head has been rebuild and resurfaced...
  6. Transmission & Rearend
    I recently rebuilt the 4l60e on my 2000 S10 4.3L 2WD. It was slipping out of 4th while in D so I drove it for a week in 3. Eventually, 3rd gear was slipping, especially when warmed up, so i decided to rebuild. I got a vacuum tested reman valve body from Shift Rite Transmission shop with the...
  7. Member Projects
    Hello community, Just wanted to provide an update on my 2000 S10 ZR2 project. So the 33's are on with the help of a 2" body lift. The wheels rub still when turning so its a good thing a bought a 2" suspension lift. When i first got this truck around a year ago it wasn't running and have since...
  8. Transmission & Rearend
    Howdy, on my 96, rwd, 4.3 posi doesn't kick in most of the time, it will usually kick in but has to be very high rev range and I get the usual embarrassing 1 wheel peel. I don't really know what to do about the rear end, install new clutches? what are your recommended rebuilt kits if that's the...
1-8 of 8 Results
Top