S-10 Forum banner

Discussions Showcase Albums Media Media Comments Tags

1-4 of 4 Results
  1. 262ci Forum (4.3)
    Had bought a project s10 from scratch (no engine). Pulled a 98 Blazer engine (which should be the same from reading interchangeable). What parts were replaced (new): Coil Ignition Control Module Cap and rotor (old was corroded and damaged from the inside) Spark plugs and wireset (ACDelco...
  2. S10 / Sonoma
    I'm not sure why I could be getting no spark. I had an aftermarket cd deck I installed in my truck and one day I had the truck running and I bumped the radio and the truck started to shut down so I wiggled the radio and the truck went back to running normal again. I later on switched out the...
  3. 2.2L - 2nd gen 4-banging
    This is a good strong engine with low miles and was running perfectly until it just STOPPED running as I was cruising down the highway in the rain. I initially suspected the fuel pump as it had been "noisy" as of late.. So, Pump was replaced, it's fine and working if I bypass, relay is good...
  4. 2.5L - 1st gen 4-banging
    First time user and appreciate any feedback. I have a 1992 GMC Sonoma with the 2.5 L 4 cylinder with 5 speed manual approx 140,xxx miles. Recently, while idling on warm up the engine completely quit in my driveway. No spark was identified at the plugs or coil. I took the cap off and to check...
1-4 of 4 Results
Top