S-10 Forum banner

Discussions Showcase Albums Media Media Comments Tags

1-11 of 11 Results
  1. 2wd
    I have a lifted 2.2 5speed dime that I need some upper control arms for. Balljoint angle is wildly off and as you all know, aftermarket support for our dimes is basically zero in 2022. If anyone is a fabricator or knows one, I would like a set built. Send a pm or drop some other suggestions! Thanks!
  2. S10 / Sonoma
    I bought a 2001 s10 crew crab ls… a lot of work was done to the truck including being lifted. I now need to replace the ball joints but the stick ones don’t work since the control arms were obviously swapped as part of the lift. Would anyone know how I can identify the lift used or what ball...
  3. S10 / Sonoma
    I recently bought an 01’ crew cab LS with a lift, I believe 2” plus 32” tires so a overall lift of 3” or so… I’m looking to get new shocks because I’m 99.9% sure the previous owner kept the stock shocks on it; they look original and they ride like absolute crap. What would you guys and gals...
  4. Liftin' It
    I am lifting my 1992 gmc Sonoma a total of 8 inches 5" suspension and 3" body lift, I am running 3.42 gears with a 5 speed manual I wanna go with the tallest tire possible any suggestions please
  5. Liftin' It General
    I’ve finally got my first truck back, (a first gen S10 durango, 2.8L, extended cab, 5-speed, 4x4) and I’m ready to put some money and work into it. Im planning on making it a little overland-type truck, that can do some light towing. Not exactly a crazy crawler. Im not exactly asking for a how...
  6. 2.2L - 2nd gen 4-banging
    Hello, im wondering if i could fit 31/33 in tires under my 98 s10 with no body trimming. And if i need a lift would a 2 in be enough or would i have to do a 6 in lift
  7. Wheels, Tires & Brakes
    Ive been dealing with some highway speed vibrations and have slowly decreased the amount of vibration by replacing a few parts. However there is still a slight vibration. So I decided to jack the front end of my truck up and noticed that my drivers side tire/wheel spins freely pretty easily...
  8. 2wd
    I finished the Rear lift. Did the shackles and had to order new mount plates and U bolts for the shocks to get then on since the stud was so rotted out she snapped. Now how do I go about my front lift? I have new spindles, brake lines and front shocks. What needs to come out to get the spindles in?
  9. Wheels, Tires & Brakes
    I am lifting my truck 2.5inches and am looking to upgrade my rims and tires to 31 inches tire and 15-16 inch rims. I looked at the offset recommended and it says 50mm stock. Is that correct? I can’t seem to find any pro comps or steel rims with this information. My rims now poke out 1 inch in...
  10. The Send10

1-11 of 11 Results