S-10 Forum banner

Discussions Showcase Albums Media Media Comments Tags

1-6 of 6 Results
  1. S10 / Sonoma
    hello all, i have a 98 S10 ZR2 and i recently had the front end replaced (control arms, tie rods, etc) but i recently went to get an alignment and the left wheel won’t go further than -4.8 degrees of camber. the front right wheel moves perfectly for the alignment but the left will max out at...
  2. ZR2 - BlaZeR2 - Highrider
    I've got a '96 ZR2 that needs new ball joints (upper and lower). When I looked at it last some of them still were riveted into the control arm. I can't remember if it was the uppers or the lowers. Just wondering what the best/cleanest/easiest way to get the riveted ball joints out is. Any advice...
  3. 4wd IFS
    I have lifted the front 6 inches and the rear 7 inches I am trying to decide if I need to torque the keys more to get the front level with the back what's you guys opinion on my CV angles
  4. S10 / Sonoma
    Does anyone have a link for a complete 2000 Chevy S10 2.2L with 2 wheel drive front end rebuild kit, mine is going out and I can't find a good quality full one. Please help my fellow S10 owners!
  5. S10 / Sonoma
    So.... by the end of this weekend, my S10 front end rebuild * should * be done. I'll have replaced- Both Inner/Outer Tie Rod Ends and the associated adjuster sleeves. Both Front Upper Control Arms with Ball Joints. Both Front Lower Ball Joints Both sides' front brakes and rotors. (cheap-ish...
  6. S10 / Sonoma
    So this past weekend, I started work on my newly bought S10 (1998, v6 - engine W, Zr2 package, sport chassis, fleetside bed, 4x4) it's a little beat up, so I knew going into it that it would need work. I bought a front end kit to do my front end suspension, basically everything but shock...
1-6 of 6 Results
Top