S-10 Forum banner

Discussions Showcase Albums Media Media Comments Tags

1-5 of 5 Results
  1. 262ci Forum (4.3)
    Hello all, I have a 94 S10 2 WD 5 Speed 4.3. Recently spun a rod bearing so decided to do a weekend swap with a 4.3 out of a 95 1500. Everything switched over fine, had to replace the oil pan, motor mounts, and oil pump. I changed the flywheel from my old motor and installed a clutch and...
  2. S10 / S15
    I'm getting to the end of swapping out my clutch on my 92 s10. I'm installing a new clutch release cylinder, a couple questions: 1) When I bleed it, it has to be installed, yes? Otherwise if it's not pushing against the clutch fork it could blow out the hydraulics, right? 2) At what point do...
  3. Transmission & Rearend
    Came around a corner normally, went to grab 2nd then 1st dumb dog came in front of me, then lost my whole drivtrain when I shoved it into 1st. I just used my brakes didn't let out of the clutch. Looks like it is pressing on pressure plate fingers when I look through my clutch line peep hole. I...
  4. Transmission & Rearend
    Does Anybody know where to get a clutch for a 1984 s10 with a stock Isuzu c223 2.2 diesel? If I order a flywheel at Napa they send me one that the friction disk matches the transmission but the cover does not match the flyweel. I just did a complete rebuild and the new clutch is what I'm waiting...
  5. S10 / Sonoma
    Ok Folks, I have a 1998 S-10 and I have recently turbo'd the 2.2l. 5 spd manual trans. I need to replace the clutch (again). I am not hard on the clutch and often shift without the clutch but I drive a lot of miles though (she's got 500k!) This is the 5th or 6th time replacing. When I bought...
1-5 of 5 Results
Top