S-10 Forum banner

Discussions Showcase Albums Media Media Comments Tags

1-4 of 4 Results
  1. Steering & General Suspension
    🤔After years of an issue of not knowing why does the new castle nut after being torqued to specs, is lower than the hole for cotter pin? Replaced control arm with ball joint pre-installed and the issue is the wear on surface on spindle. After speaking with a Manufacturing tech, the taper of the...
  2. ZR2 - BlaZeR2 - Highrider
    I've got a '96 ZR2 that needs new ball joints (upper and lower). When I looked at it last some of them still were riveted into the control arm. I can't remember if it was the uppers or the lowers. Just wondering what the best/cleanest/easiest way to get the riveted ball joints out is. Any advice...
  3. S10 / Sonoma
    I bought a 2001 s10 crew crab ls… a lot of work was done to the truck including being lifted. I now need to replace the ball joints but the stick ones don’t work since the control arms were obviously swapped as part of the lift. Would anyone know how I can identify the lift used or what ball...
  4. S10 / S15
    My truck is a 1991 s10 4x4 and I'm trying to understand this. The mechanic claims to have not touched the tie rods, only replaced the upper and lower ball joints. Now the truck pulls hard to the right. It went pretty straight before. Am I missing something here? What would cause that...
1-4 of 4 Results
Top