S-10 Forum banner
5 speed
1-8 of 8 Results
  1. Transmission & Rearend
    Came around a corner normally, went to grab 2nd then 1st dumb dog came in front of me, then lost my whole drivtrain when I shoved it into 1st. I just used my brakes didn't let out of the clutch. Looks like it is pressing on pressure plate fingers when I look through my clutch line peep hole. I...
  2. S10 / S15
    I have a 1991 S10 (4.3L with 700r4), and I was wanting to throw an NV3500 in there. I know I need everything from a shift knob to the pedal assembly. I know I'll have to cut a hole for the shifter, but as far as installation I don't have a clue. Would I have to get a new crossmember? Would I...
  3. Baby tahoe

    1992 s10 blazer 2 door 2wd 5 speed
    No image available
  4. V8 Discussion
    Hey guys I have a 98 S10 with a 4.3 and auto transmission with electric 4WD, I’m getting ready to swap a Carb 350 and a 5 speed NV3500 out of a 97 Sonoma my question is my donor truck is a floor shifter 4WD would there be a way to keep my electric 4WD sense nothing in my truck will require a ECU...
  5. V8 Discussion
    What's up my s10 people, I have a 1992 s10 Tahoe fleetside pickup it currently have a fuel injected 4.3L with a 5 speed 4wd transmission ( I'm not sure of the model transmission). I would like swap a (3970010 stamp) 350 engine into it. My question is can I keep my transmission? I would like to...
  6. 2.2L - 2nd gen 4-banging
    After driving for a few mins when I come to a stop and the truck will start idle weird it will rev down then back and repeat until I out pressure on the gas pedal but today I found out that if I have my defrost on it will idle fine has anyone had this issue this is my first s10 and first over truck.
  7. 262ci Forum (4.3)
    So I'm planning on putting a 4.3l from a 91 blazer into my 86 s10 and I was wondering the best 5spd manual to go with it. Not too worried about having to cut holes or anything but if i dont have to id rather not. Thanks
1-8 of 8 Results
Top