S-10 Forum banner

Discussions Showcase Albums Media Media Comments Tags

1-6 of 6 Results
  1. S10 / Sonoma
    I have decided to follow my passion with tiny trucks and being the local drone guy for my buddies in the drift scene. i want to party on the track as well. I own a 1998 chevy s10 2.2L 4 cylinder and looking to do a swap with a 4.3L non-carb V6 with a small single turbo if possible. i would...
  2. 262ci Forum (4.3)
    I have a built 4.3l pushing 300hp and I'm going to drop it in a 1984 Camaro. I am having trouble finding a set of engine mounts I can use. I saw transdapt makes mounts for swapping a 350 in an s10 and I wondered if I could flip them around to work the same for a 4.3l in place of a 350. It seems...
  3. Blazer / Bravada / Jimmy / Envoy
    I have 2 1988 chevy s-10 blazers 4x4, 1 with the 2.8l manual and the other with the 4.3l automatic. The 2.8L engine is blown and I want to swap the 4.3l in but I do not know if the 4.3l engine will bolt up to and work with the manual transmission from the 2.8l. I also want the 4x4 to still work...
  4. Articles - Engine, Other
    Hello I'm new to the S10 community and to this page but it has been very enjoyable so far. A lot of good people on here. I have a 1999 Chevy S10 base model 5-speed two-wheel drive with the four-cylinder in it. I have about 190,000 mi on the motor good running clean little pickup it has a few...
  5. Transmission & Rearend
    I apologise if this has already been discussed. I have a 4-cyl 2002 S10. I'm planning to build a 4.3 (balance shaft motor) for it. Are the bell housing bolt pattern a the same between the 4-cyl and the 4.3? Thanks
  6. S10 / S15
    Hi people! Just picked up my first S15, 1985 4x4, 2.8 V6, 5 Spd manual with 42,000 original miles. I’m learning and reading a lot but here’s my question. This 2.8 is a sluggish dog in my opinion. I know it needs a tune-up but other then that runs real good. My first thought is this needs a...
1-6 of 6 Results