Search Results for ‘2003’

This is my first time doing this. Mainly I need to know what tools I will need and in what order so I can rent/buy them as needed also if anyone could link a video for me I am having trouble knowinvg if the videos i find are on the correct engine. I have changed my own oil a few times on a civic...

I have an '03 base model S10 2.2L 5 speed. Got the GS401-10650C coilover kit and have attempted to install it, but I encountered some problems. First the spring did not allow the shock piston to go into the upper hole far enough to see threads even with the spring adjuster bottomed out. I...

I'm not sure why I could be getting no spark. I had an aftermarket cd deck I installed in my truck and one day I had the truck running and I bumped the radio and the truck started to shut down so I wiggled the radio and the truck went back to running normal again. I later on switched out the...

Hello everyone I have a 2003 Chevy s10 4.3 & recently I been having a problem where when the truck sits for 4 hours or so the truck doesn’t start unless I press the gas straight to the floor (fuel injected vehicle). After that it runs at high rpm and almost sounds like I have a cam (which I...

Aloha Guys! I own a 2003 S10 2.2L, Manual 5-Speed. I recently had a my check engine (or "Service Engine Soon") light illuminate. I keep up with all maintenance so that's not the issue. I tried to connect a scan tool to my OBD-II and I found that I had no signal coming from my OBD-II to connect...

My '03 S10 4.3 SES light came on, and my mechanic said it was bank 1 sensor 2 o2 sensor. Which o2 sensor is it that needs to be replaced? I would like to do it myself to save some cash, but determining which sensor is bank 1 sensor 2 on my model seems to be a source of debate... A diagram for my...

I Currently have a 2003 Chevy S10 that needs a motor. It previously had a 2.2L 4cylinder motor in it. Im in the process of bringing it back to life but I wanted to know what other engines were compatible without doing much modifications? Thanks

Ok guys I'll try to keep this short. I have a 2003 S10 ZR5. I installed new front rotors and pads, during which I had removed the calipers to clean them up a bit. I let the disconnected front brake lines bleed out. After reinstalling the calipers and bleeding the lines the pedal was extremely...