S-10 Forum banner

1993

  1. 60v6 Forum (2.8/3.4)
    Hey all, this is my first post so sorry if I get anything wrong. I've recently been working on my S10 and have had a problem with it where the check engine light is on, and when the engine revs, right after, it drops very low and almost dies, but then returns to normal idle. I've recently...
  2. Trucks For Sale
    https://boone.craigslist.org/cto/d/boone-mechanics-special-rolling-resto/7182760760.html Included Parts: Timing Set Motor Mounts Full Gasket/Seal Set Clutch/Flywheel/Bearings Front/Rear Shocks Ignition Switch Kit New Parts Installed: Water Pump Alternator Battery Tires/Brakes (all 4) Exhaust...
  3. S10 / S15
    93 S10 cranks but doesnt start. The fuel pump runs but the engine isnt getting gas. I took the fuel pump out, replaced a bad strainer, and siphoned all the bad gas and trash at the botton of the fuel tank. I put new gas and now it still wont start. What should i do?
  4. S10 / S15
    I just bought a 93 s10 and it has a fuel issue. I'm pretty sure its bad gas because it's been sitting there for a year or longer and i want to empty the gas tank. I pulled the bed off but now i can't seem to find out how to take the fuel pump lines off. The fourth line doesnt have a screw or...
  5. Member Projects
    I just bought a 93 s10 and it has a fuel issue. I'm pretty sure its bad gas because it's been sitting there for a year or longer and i want to empty the gas tank. I pulled the bed off but now i can't seem to find out how to take the fuel pump lines off. The fourth line doesnt have a screw or...
  6. S10 / S15
    I have the 3.08 rear end ratio in my 1993 S10 and I’d like to make it limited slip. I’d like to get a posi rear end that’s similar but I don’t know how that would work since I have 4wd. I don’t want it tearing itself apart. So what should I look for and find in regards to rear ends. And how do I...
Top