- I need to trick my EGR valve.. idles baddd.
- Can you figure this out...
- What kind of oil additive?
- AC DELCO #746KK plug wires ?
- What gaskets/seals should I replace before droppin in a 4.3
- IAC valve location?
- NO Spark Check Pickup Coil?
- Getting the truck back
- Injectors dying?
- 94 s10 blazer ignition issue
- need help guy
- need help asap
- Faild emission test..
- 4x4 issues
- BD and now the injectors aren't working???
- K&N CAI falling apart
- heating issues need help fast!!!!!
- 4.3 idles bad and a smell of antifreeze
- 94 CPI Oil in upper intake
- 94 jba headers spark plug problem
- Replace head gasket? Sludgy coolant, low oil pressure.
- Wanted to say Thanks for what you do!
- Thermostat
- coolant
- BAD Coolant Leak on rear of engine.....HELP!!
- sending unit/fuel pump plastic ports/fittings?
- replace motor?
- cold air intake
- fuel pump pressure?
- Randomly dies....
- fuel pump
- Sulpher smell
- tried everything i can think of, won't start
- 4.3L for my CJ
- Oil pressure down and valve train ticking
- Posted this in 2nd gen forum but figure this may be better spot
- idles high when cold
- 01 4.3 cam
- 50mpr in 2 gear
- 50mpr in 2 gear?
- Timing adjustment on a 2000 S10
- Cold engine and no power????
- How can I get heat from the vents, instead of the floor?
- Help is this the switch I need?? 4x4 problem
- inconsistant idle at cold start
- will a custom dyno tune....
- Pics of my broke ass driveshaft
- Truck won't run at 0 degrees timing.
- Shift Points
- 4x4 trouble
- MAP issue
- Heat went bye bye
- 2.6 to 4.3 swap problems
- truck power declining
- P0108, P0507, P1509 What does this mean?
- question
- 96 Vortec V6 Rebuild Questions
- missing or bogging problem i dont know
- Evap Code ON/OFF/ON/OFF/ON/OFF HELP
- Poor old truck died..
- brake light stays on
- comp cam 266
- upgraded ecm?
- Cold starting problem.
- Advice on how to break loose LIM
- bravada runs rough at idle
- lifter tick at cold start
- Starting issues
- Do I use Lucas Transmission Fix or Not?
- questions on stock internals... please help