- converting form a 2.5 to a 2.8
- setting the advance curve on the vacuum advance distributor. Anybody know how?
- Swapping 2.5 with 2.8 tranny question
- 03 4.3 vortec no top end
- Need help with Emission test
- extreme lack of power
- 2.8 Transmission...
- will a 700r4 from a camaro work in my 2.8 4x4 jimmy?
- 2 questions
- WANTED 4.3 Carb
- 2.8 switch over
- starter???? 2,8
- 2.8 to 4.3
- Holley 5.7L TBI Work on a 3.4L?
- 2.8L Exhuast....HELP! what do you have?
- Headers in a 2.8?
- Fuel Filter Replacement question
- Acts like it is running out of gas... help please!!
- any answers ???
- 1984 s-10 blazer 2.8l carburetor
- 3.1l and 700r4 in an 82 dime
- 2.8 beretta help
- 3.4 questions
- Has anybody dyno'd the Holley 4 barrell on a 2.8?
- 2.8 Engine Removal
- Other choice for 3.4 harness/ECU ?
- 4.1 Buick swap?
- fixing some other things - exhaust leak and eng clean
- Does this ebay thing really work?
- I could harldy pass em, please help me
- whats everyone elses like?
- tbi flooding
- old engine tuning?
- Wiring harness, pull with engine?
- belts baby
- threaded fuel fitting sealant? what do you use
- engine swap question
- tips for carb'd (older) s-10 owners - troubleshooting
- performance heads for the 2.8
- will this work?
- little help needed
- 2piece or single rear seal block?
- Spacer between carb and intake manifold?...
- fuel gauge f***ed
- cruise control switch
- 2.8 topic questions
- How-to '84 carb to '87 fI?
- 3.4 engine numbers
- Temp gauge not working
- chip the problem?
- 2.8 vacuum diagram
- Motor Trouble, need help
- Reliability????????????? Need help!!!
- Brake pedal = stall
- Factory Tach Connection on '87 S10
- starter on 87 s10 blazer
- 2.8/3.2/3.4 times
- Run sumpin by ya? (carb, fuel lines)
- 3.1 lumina crank in a 2.8?
- GERMAN S10 2.8L driver
- so who here has done a cam swap on the mighty 2.8?
- lengthy carburator/timing questions, need help!
- Going backwards... F.I TO carb 2.8
- Oil viscosity
- Messed up oil pressure gauge
- What distributor is on my engine 3.4 carb
- 3.4?
- Anyone run Edlebrock cam and lifters?....
- 2.8 carb questions
- carbed 2.8 suck