View Full Version : 60v6 Forum (2.8/3.4)
- new 2.8 mod
- 1992 S-10 Mileage
- Optimal exhaust piping size for a 2.8 or 3.1
- Holley carb with issue
- 96 engine turns over but doesnt start
- porsche 944 swap???
- I need help!
- engine rebuild/swap progress!
- 84 S-10 2.8L, Engine Swap ?s
- 2.2 to 3.4 or 3.8
- motor swap??
- Water pump!!!!!
- Holly 2.8 TBI OEM specked
- How long is your dipstick?
- valve lash
- 3.4l tbi ecm chip?
- Mystery wire
- ebelbrock cam
- Can I put earlier 2.8 in 87 S10 Blazer?
- turbo stand alone??
- 2.8 3.1 stroker ????
- Finally!!!!
- How to set the RPM with remote 2.8L coil
- raising compression with 75 shot n20
- turbo
- s10 heads
- crazy h.p. loss
- vibration?
- Easiest Swap For 2.8L V6
- How do you prep a truck to go swimming?
- How can i tune up my 2.8?
- truck wont shut off with key
- distributor stuck
- cure for a weak spark
- blazer wont start
- question to you cats (muffler decarbonization)
- Camaro V6
- high idle after rain
- how to remove o2 censor, and any way to clean a cat? ASAP
- computer codesss???
- Y Pipe for a 2.8, whats it worth.. factory?
- knock sensor on 3.4l
- Trouble codes 32 and 43?
- 84 blazer acceleration problems
- ebay "supercharger" heard anything about it????
- starter problems..... and lots of them.
- 87 2.8 in a 84??
- 87 2.8 running extremely rich.
- deal...or no deal?
- intake questions
- HELP HELP ASAP 92 S-10 with 2.8 V6,
- need air cleaner housing
- i need 200 hp from a 85 s10 2.8 5speed
- what are specs on a 2.8L v6?
- Injector gasket???
- Ignition switch locked up
- If Not 1 thing its another....
- Which Edelbrock manifold for Holley 390 swap?
- 86 blazer wont start
- need some pics of 2.8
- wire harness
- All aluminum 2.8 including heads Gen 1
- 85 2.8 questions..
- Returning with new S10
- where is my casting number?
- Anyone along/near I-40, I-20, I-77, I-79 need any parts? Block, heads, intake, etc...
- Gas economy
- 85 2.8L timing
- 3.4 dohc
- Valve cover questions