PDA

View Full Version : 60v6 Forum (2.8/3.4)

Pages : 1 2 3 4 5 6 7 8 9 10 11 [12] 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50
  1. need help
  2. starter solenoid wiring on 86 2.8
  3. Holley Throttle Body
  4. might be gettin a 2.8
  5. 2.8 to 3.4 Swap - Injector Upgrade Question
  6. 87 S10 4x4 Tune-Up Questions?
  7. Other Years that will work
  8. Oily Air Filter
  9. EGR problems, need diagram
  10. truck stays running, after key is in off position and out
  11. gas tank size
  12. 3.4...???
  13. inline fuel pump
  14. Help! No Heat!!
  15. fuel pump always on?
  16. Takes a while to start?
  17. 90 s10 wiring problems
  18. no oil pressure
  19. 4.3 vortec
  20. Motor mount problem!!!!
  21. water pump rotation
  22. another 2.8 runnuning isue
  23. need info on headman headers
  24. Constant Speed Water Pump?
  25. need help truck runs great but barely moves.
  26. Truck wont start
  27. This probably has been posted...high idle.
  28. '95 V Vortec.
  29. Smoking ECM
  30. Cam question
  31. 2.8L 5 Speed
  32. Intermitant rough running 86 2.8
  33. how do i get better gas milage
  34. MAP Sensor
  35. stuck high idle, tricky
  36. Sqaure Carbs
  37. Cleaner Assembly help
  38. 91 2.8 isssues
  39. parking lights /dashlights
  40. 2.8 Air Cleaner Lid?
  41. Grand National 3.8L V6 TURBO swap
  42. What heads?
  43. 85 4x4 s-10: dropping the oil pan (new gasket)
  44. what u think of this from ebay 3.4
  45. 2.8 to a 3.4 swap....
  46. oil pressure...
  47. more timing problems, a really tricky thing
  48. NE1 have an old fuel sending unit?
  49. replacing parts for longer life
  50. What happens when you run without knock sensor?
  51. knock sensor
  52. Plugs wires on cap, is this where #1 goes?
  53. 3.4 stroker motor
  54. Heater hose/vacum hose?
  55. did alot of you buy used 3.4 or new ones
  56. carb heads and efi heads?
  57. no fuel no start
  58. Moates tuning!!
  59. Some help please 2.8 tbi
  60. 2.8 engine swap...84-89
  61. 4.3l vin z Idle surge when cold
  62. 4.3 and 2.8 interchangability?
  63. Cranks, but no start or fuel
  64. cam's and headers
  65. OIL PRESSURE DROPPIN?!?! Please help ASAP!
  66. 86 0r 87 2.8 flywheel question
  67. 84 s15 jimmy carb issues?
  68. 84 2.8 to a FI 3.4
  69. replacing the rear main seal
  70. 2.8l oil pressure

SEO by vBSEO