- Timing ???
- Gasket on 2.8 distb.
- Help, truck stays running with key off.
- will a 89 fi camaro 2.8 work? in a 85 carb s10?
- Mods for a 2.8?
- bogs down in fifth
- swaping in 3.4 got some Q's
- What size inj ?
- won't start
- vacuum lines help
- how much power do you think i can get out of this
- Removing smog pump?
- Cross country trip...towing a heavy car
- bogs up hill (newb)
- Pull pistons through oil pan?
- Overheating
- 87 blazer wiring same as 89 fullsize?
- carb help for my 2.8?
- 85 2.8 carburator overloading
- 2.8 Engine Codes
- Underdrive pullys
- will a 3.1 rwd engine bolt to a 2.5 rwd trans??
- has spark and gas but wont run
- Bolt on headers for the 2.8
- No spark please help
- 2.8 water pump question
- need help
- oil pressure sender?
- Do i need my cat converter?
- AC blows next to windshield only ?
- 87 TBI idle adjustment
- 2.8 rebuild
- 3.8 question
- suggestions for ultimate 2.8L build
- 2.8 cross over
- 2.8 with 4.3, what in the world.
- 3.4 bits for a 2.8 motor
- 3.4 new but what now?
- test
- Air blend actuator
- Compatible intake manifolds?
- Can I tow a boat?
- 4.3 and 2.8 TB differences
- Is my headgasket bad?
- this is an awsome 2.8 i found on the web
- Where is the slave bleeder valve?
- motor turns over, than it doesnt, than it does...
- help please
- still high idle 91 WTFlip
- 2.8 to 3.1 Hybrid
- tranny fluid drips on y-pipe (85 s10 4x4)
- Need some help
- 3.4 Swap Questions
- Reversing Polarit.
- Cold Air Inatke
- Problems
- MSD ignition
- hows my heads look?
- Cold Weather Starting Problems
- finally found the 2.8s problem. need torque specs
- 1986 S-15 idle issue?
- 1.6:1 with aftermarket cam?
- holley carb Queston
- I'm completely stumped (no fuel prime)
- Gasket between oil filter housing & block
- 2.8 to 3.4 question
- 94 3.4, Blown head-gasket and knocking. what fun
- Choke Question
- Choke Question
- 2.8 / 4.3 T.b.i. ?