S-10 Forum banner

Reaction score
333

Profile posts Latest activity Discussions About

  • · Registered
    Joined
    ·
    8 Posts
    I have a few questions about your Hanna



    I am starting Nadine a 39/40 pickup project I picked up a 39 and a 43 for parts

    Still looking for rear fenders



    I have scrounged up an S10 how does the front fit on for the 39 - 46 model width wise ?
    Cab mount rubber you say camaro which year range for the cab bushings

    I found Jeff's cab mount design for a AD truck Will the AD cab mount design work for the older trucks ?


    My plans are put the 39 on the S10

    big brake it with stock chevy parts

    12 bolt rear diff with disc brakes

    Set it up as a short box most likely

    I found a 4.8 LS and have a richmond gear 6 speed to make it get up and go



    I plan on getting the cab rolling on the new frame this summer and work on the engine drivetrain this fall



    Too many projects and no money

    39 chevy truck

    51 chevy truck

    72 chevy 4x4 my dads truck have a sweet vortec 350 roller cam to build for it

    · Registered
    Joined
    ·
    0 Posts
    Hello, I was looking around on the internet to see if anyone had used the stepper motors from the newer GM Gauge Clusters to retro-fit old gauges. I found a picture using google search that looked like that is something you have done. All the pictures are not showing up due to the new Photobucket policy. Did you cut up a circuit board with the stepper motors and then wire to them from a different circuit board? I was considering mounting steppers on plastic placed inside the gauge and then using a circuit board from a Silverado located somewhere under the dash and removing the original steppers. Then wiring from the original stepper locations on the circuit board to the remote mounted gauges. It seems like it will be a mess of wires and a lot of un-needed space but would work. Anyway just curious what your experience was with your project.
  • Loading…
  • Loading…
  • Loading…
Top