Joined
·
13 Posts
Hey, I'm working on trying to convert my 93 4.3TBI from a 5-speed to manual. I saw in a thread where you had gotten your 16168625 ECM to run e-fans high and low, and was hoping I could pick your brain a bit. I just got an AutoProm and have all the hardware set up to read and burn my own chips, as well as emulate a tune, but that's about as far as I've gotten so far. I've obtained the code for the fan control on the $E6 ECM, but I could use some advise in how to integrate it as well as shutting off all the automatic garbage since I'm now running a manual. If you have a .bin handy, that'd work too, and I could just burn that on my secondary chip and tune from there. I'd appreciate any help you could provide. . . Thanks bud
~Phil
~Phil