- Gauge problem
- 1999 S10 Blazer intermittent starting problems
- 97 to 98+ pcm swap?
- back freeze plugs
- 4.3 won't idle + other problems
- 99 ZR2 Shutting Off
- prefered aftermarket intakes for a 97?
- opinions please
- "TUNE UP" help with my '94
- Canister under Air Filter box
- Tranny Dipstick
- Tech Q.: can I use the Hayden 3647 as thermostat ONLY?
- Watch your Oil level. Dont overfill.
- Not sure whats wrong...
- hi flow oil pump
- hi flow oil pump
- hi flow oil pump
- how to raise rpms!
- Fan blades broke = rough idling motor??
- Ohio's dragway 42 this friday!
- 1997 4.3 not starting anymore!
- '89 runs like pooh!
- Has trouble starting and keep running
- 94' Bravada Dipstick Tube R&R
- Cheapest place to purchase MAF sensor.
- Taurus eFan IT WORKS - THANKS a million guys
- I think my Front Hub Bearing is bad!!
- Distributor installation. I need help!!!
- got it wet!?!?!
- which programmer
- rev limiter
- starting issues
- Exhaust leak ?
- Few question from new owner
- Taurus eFan didn't work - another eFan or back to clutch?
- write up on...
- Fuel Fittings
- IAT sensor relocation
- replaced fuel pump and fpr now what?
- TBI injector question/misfire
- Question on CPI & TB Engines
- headers, specifically '93-ish, VIN W
- Hard to get my 94 Vortec V6 strated
- Found a TBI cold air intake for you TBI guys
- Rough Starting
- shaking...
- What cable is this?
- Alternator with underdrive pulley
- Those damn 02 sensors!
- 1991 fuel guage problem
- I think my fuel pump is bad
- problem with p0304
- Build a set of heads?
- Installing a oil pressure, volt, and water temp gauge
- CEL 44 lean exhaust
- *Starting Issues?*
- 4x4 problems..
- What brand oxy sensor?
- little help needed
- Speaking of overheating... 262 probably needs headgaskets
- my S10 is overheating, HELP!!!
- 2000+ 4.3 swaped in place of tbi (91) 4.3
- Stripped Out Oil Pan Drain Plug
- 2002 4.3L Running At 210 and going higher
- Rough Idle?
- no o2 sensors?
- fuel pressure reg
- My truck overheated
- REPLACING auto 4.3 with 5 speed 4.3
- vibration?