- 1000Mi Road Trip Info (gas mileage, etc)
- wanting to put a 2003 4.3 in a 1992 s10
- oil pan
- my build thread(bout time eh?)
- Block heater?
- speedometer question
- who says 2.8s are slow :P
- Tearing down my 3.4..finally! Some questions.
- top out
- Help on Bringing my S10 back to life
- Shredding belts
- I thought my engine was siezed...
- spark plugs for 1987 2.8
- Whats a 3.4L camaro engine worth?
- 82 2.8l swap to 3.4
- need some help
- Problem with engine, 86 Jimmy S-15
- '89 2.8 spit back through TB
- A few questions about timing
- 85 2.8l 4x4 just short blocked
- Transmission sticker shock!!!
- Question About Throttle Body
- Edelbrock intake
- Truck idles at around 215 degrees
- Windup dash noise.
- How can I tell if my carb is a Cal or Fed
- speedo?
- aldl has no output cant set iac
- I should be happy.
- Head Gasket?
- 85 blazer vacuum hoses
- a/c compressor issues
- How To Put A Turbo On A 93 2.8L S-10
- Bigger alternator upgrade
- Fast Idle
- Fuel Upgrade
- Carb base gasket
- eliminating stuff under hood
- Engine shuts off after 2 mins of idle.
- PCV valve/air breather swap?
- Annoying Surge
- best carb?
- Where the frick is the ignition coil???
- engine hepl asap...
- converting to 5spd.
- different varajet carbs?
- under the hood
- Well I'm stumped
- couple of questions
- Where are the id numbers on the 2.8?
- distributor/timing issue..won't start
- Potential issues?
- Headers for 2.8 4X4 Auto?
- what trucks came with the 3.4?
- which fuel lines are which?
- 2.8 water neck
- decision time
- T.B. to feul injection???
- o.t. body diagrams?
- increase gas milage
- Help Quick!!!
- look what i found ...
- cleaned up my 2.8 a bit tell me what u think
- crankshaft problems
- comp cam, roller rocker in a 2.8
- Edelbrock Intake Manifold for TBI
- motor is overheating
- 2.8L Cold Air Intake
- emissions help for a 2.8
- air cleaner ?