- long block for sale
- 3.1 question
- Electric Fan Sending unit question?
- 2.8 stroker or 3.4
- 2.8 help... that is if you dont mind
- back with some carb questions
- 2.2 to 3.4 (friends ride)
- 2001 s10 4x4 help
- stalls afer sittin for 10 mins
- Dash lights
- Failed Emissions - High Hydrocarbons - HELP
- Vac Hose System Questions
- 2.8 Running Bad
- Need help with 2.8 engine (oil cooler lines)
- Wont Pass PA Emissions???
- 84 blazer 2.8, sputtering under acceleration
- 82 s10 valve noise and odd idle
- edblebrock intake manifold and TBI
- MPFI or Carb?
- E3 Plugs
- Vac Hose Importance
- 2.8 - 4.3 swap ! Yes i Searched....
- # Of Vacuum Ports On TVS
- 4.3 cooling issue
- help with spark problem
- need help with 2.8
- 4bbl Intake for 60deg
- 2.8 Carbureted Vacuum Diagram
- Huge 2.8 problem!!! Need help!
- Lost timing & reset valve lash, engine wont run right
- What can I swap in?
- Help finding the engine VIN
- TBI Swap questions
- Heater Core????
- Rebuilt Camaro engines under a grand!
- air pump removeal. belt size?
- 2.8 header problem
- Head gasket for 2.8L help
- new speedo cable and now no wipers
- damn semi
- 1985 2.8 carb-ed loss of power when wet
- Need pics of "Distributor Vacuum Regulator" and "Distributor Vacuum Delay Valve".
- 2.8 rpms
- 3.4 95 camaro engine in a 88 2.8 s10?
- TBI / Intake?
- My 87 S10
- What wire goes where?
- 2WD to 4WD
- she's gettin hot on me...
- '85 s-10 4x4: Help finding new charcoal canister
- Ed. 4 bbl Intake on eBay
- What's frustrating about about having a 93 2.8?
- thermostat opening late - maybe ?
- Sharp eyes...check this out.
- Vibration about 1100-1800 RPM. help!
- disconnect battery to start
- 2.8 Injector acting up WTF?
- Doing Holley 4bbl/Ed conversion? A cool tip!
- 2.5 to 2.8 swap questions
- gas mileage
- 2.5l t-5 tranny bolt to 2.8?
- Hydraulic clutch quick connect trouble.
- 2.8/3.4 cam timing?
- vac lines
- 2.8 mods
- Holley 390 carb tuning--any pointers?
- Burnt out donut gaskets. Clogged cat?
- Coach1
- engine rebuild!
- 3.4 Ht