- please help
- 91 fuel pump fuse?
- PVC Oil Catch Can
- pullies
- Has anyone swapped a 3800 Buick V6?
- need to get cooler
- Hmm, no pass on emissions - 1st time seen this one
- Which is the lean/rich mixture screw?
- Where is O2 sensor?
- Gas lines..
- getting tranny and engine apart
- What is the crank fuse? Where do I splice new wiring harness into existing circuit?
- where does the vapor canister purge line connect TBI
- Distributor replacement
- need a new distributor
- giving the 2.8 some extra umph
- Yet another (but different) "2.8L TBI Won't Start" Thread...
- Need to pass emissions/general maintenence
- 2.8 questions
- pullies
- Air conditioner refurb?
- 86 2.8 to 3.4ht swap problem
- block cracked???
- 2.8 to 3.1 stroker
- starting issues?
- slow tach?
- 2.8 F/I To carb.
- 2.8 to 4.3 vortec
- 2.5 to 4.3 swap
- 2.8 Flywheel
- 2.8 spark plug order?
- 83 emission , where does each hoes go
- 2.8 to a 3.1
- Is replacing upper ball joint easy?
- A miss in my 03
- rocker arm stud
- I have play in my rear wheels... normal? Or wheel bearings?
- For the 2.8L guys
- suggestions?
- Just pulled the motor
- 2.8L Injectors not worign right?
- oil pan removal?
- bye bye CFI
- whats a good com for 2.8 4x4
- 2.8 to 4.3 vortec swap
- 2.8 A/C help please
- 2.8 air filter Q
- 2.8 to 4.3
- Win ALDL
- What the hell with the TBI crap
- manual 2.8 to auto trans?
- 83 S10 Timing Problems!!
- 86 S10 TBI: Removable parts
- I need a new exhaust!
- Code 43 - Electronic Spark Control (ESC)
- 3.4 Retail?
- Will taking out PS pump cause problems??
- Alternator question
- Question
- looking too pull the 4 speed out need auto tranny
- temp sensor
- 2.8L to 4.3L thorttle body
- Fuel Pressure Reg.
- 2.8-3.4 parts
- Ignition Timing Changes
- Fuel Tank
- 2.8 computer interchangability?
- Need a little help
- 2.8 to 4.3
- 91 & 87 interchangeability...